SSC
CHAMBERS FOR SALT FOG

Our Salt fog Chambers are studied for the accomplishment of the existing normative for corrosion testing, in a controlled environment. With this generation of equipment it is possible to ascertain the consequences of organic and inorganic treatments on metallic surfaces, and to value possible corrosive effects emerging under aggression.
The realisation of SSC Chambers is the result of a deep knowledge of the whole normative currently available regarding "accelerated corrosion".
These equipment are studied to perform continuous tests, cyclic, multistep, fully compatible with procedures: ASTM, DIN (SS, ASS, CASS), ISO, UNI (corrosion test underfilm: in bubbles and filiform), AFNOR, PROHESION, BS, GM, CCT, MIL, RENAULT, FIAT, VOLKSWAGEN, FORD, NISSAN, BMW, JIS…

Structures are built with inert material, without any metallic part which may interfere with the test (stainless steel, aluminium, brass) and assuring the conformity to national and international standards.
Thermostatic intercapedin ("Water- Jacket") with indirect heat and uniformity of temperature in the internal, with energy saving, in conformity with technical standard ASTM B 117.
Reinforced deposit for solution, with capacity of 50 litres, allowing a rehearsal autonomy for 5 days consecutive, (120 hours); auxiliary connections to tanks of bigger capacity.
The deposit is equipped with an automatic mixer, by means of which the operator can prepare the solution inside the deposit.
Humidification and heating of air by means of "Bubble Tower", with a regulating valve, manometer, spray nozzle to attain a higher precision of temperature and humidity inside the Chamber.
The pluviometers gather the fallen solution to direct it into two external collectors, allowing a continuous measurement without need of opening the cover that would interrupt the test.
Compensating outlet for the condensation exhsaust.
N° 2 Supporters for inert material, for samples hanging.
N° 4 Castors.

Cover with small vane, anti-dropping, reinforced on side and with transparent window. Provided with automatic opening and safety system, avoiding overheating during the inspection inside the chamber and preventing any damage to the Bubble Tower and to the Chamber itself.

Programmer for cycles (99) with two steps (Fog/Dry), loop repetition (999), digital microprocessor and precision of 0,1°C, sensor PT 100 Ohm, DIN class A, autotuning PID for Bubble Tower.
Digital stop timer. The operator can program the rehearsal time, planning to stop the Chamber automatically.
Hours counter with battery back-up for the reading of the test duration.

Back / Top